Jameco-electronics Rabbit 3000 Manuel d'utilisateur télécharger pdf (Page 306)

User’s Manual 297

B.1.12 Short Chip Select Timing for Writes

The Rabbit 3000 provided the ability to produce shorter chip select strobes for reads when

in a reduced-speed mode. A new feature has been added to produce short chip select

strobes for writes as well, and can be controlled by the GPCSR register.

The new control bit for the short chip selects are listed in Table B-22.

NOTE: Bit 3 was always written with zero in the original Rabbit 3000 chip.

Table B-22. Global Power Save Control Register

Global Power Save Control Register (GPSCR) (Address = 0x000D)

Bit(s) Value Description

7:5 000 Self-timed chip selects are disabled.

001 This bit combination is reserved and should not be used.

010 This bit combination is reserved and should not be used.

011 This bit combination is reserved and should not be used.

100 296 ns self-timed chip selects (192 ns best case, 457 ns worst case).

101 234 ns self-timed chip selects (151 ns best case, 360 ns worst case).

110 171 ns self-timed chip selects (111 ns best case, 264 ns worst case).

111 109 ns self-timed chip selects (71 ns best case, 168 ns worst case).

0 Normal Chip Select timing for read cycles.

1 Short Chip Select timing for read cycles (not available in full speed).

0 Normal Chip Select timing for write cycles

1 Short Chip Select timing for write cycles (not available in full speed).

2:0 000 The 32 kHz clock divider is disabled.

001 This bit combination is reserved and should not be used.

010 This bit combination is reserved and should not be used.

011 This bit combination is reserved and should not be used.

100 32 kHz oscillator divided by two (16.384 kHz).

101 32 kHz oscillator divided by four (8.192 kHz).

110 32 kHz oscillator divided by eight (4.096 kHz).

111 32 kHz oscillator divided by sixteen (2.048 kHz).

1 2 ... 301 302 303 304 305 306 307 308 309 310 311 ... 348 349

Pas de commentaire

Jameco-electronics Rabbit 3000 Manuel d'utilisateur Page 306